Page 2
INTRODUCTION WWW.VORONDESIGN.COM Before you begin on your journey, a word of caution. In the comfort of your own home you are about to assemble a robot. This machine can maim, burn, and electrocute you if you are not careful. Please do not become the first VORON fatality.
Page 3
PREPARATION WWW.VORONDESIGN.COM Heat Set Insert...
Page 4
WWW.VORONDESIGN.COM SKIRTS M3x8 SHCS M3x8 SHCS OPTION: KEYSTONE INSERTS The picture is showing blanks for the keystone slots. Alternatively you can add modules for USB or ethernet and expose ports of the Raspberry PI on the back of the M3x8 SHCS printer.
Page 15
Z BELT COVERS WWW.VORONDESIGN.COM M3 Hammerhead Nut M3x6 BHCS...
Page 16
Z BELT COVERS WWW.VORONDESIGN.COM PINCH BELT TURN TO FASTEN Pinch the Z belt loop flat The hammerhead nut will rotate and and slide the cover in place. lock into place when you fasten the screw. At least that’s the theory.
Page 17
Z BELT COVERS WWW.VORONDESIGN.COM REPEAT FOR REMAINING COVERS Repeat the assembly steps and install the remaining 3 covers.
BACK PANEL WWW.VORONDESIGN.COM HAMMERHEAD NUTS? A drop of thread locker will turn the hammerhead nuts into a 1/4 turn quick release for the panels. Best done once the assembly is finished. M3x8 SHCS Foam Tape 1mm M3 Hammerhead Nut APPLY FOAM TAPE Use foam tape on the contact areas between the panels and the frame to mitigate noise from vibrations.
SIDE PANELS WWW.VORONDESIGN.COM M3x12 SHCS Foam Tape 3mm APPLY 3MM FOAM TAPE Use foam tape on the contact areas between the panels and the frame to mitigate noise from vibrations. The 3mm foam tape is used on the M3 Hammerhead Nut side panels to prevent the gantry from rubbing on the panels.
TOP PANEL WWW.VORONDESIGN.COM Foam Tape 1mm APPLY FOAM TAPE Use foam tape on the contact areas between the panels and the frame to mitigate noise from vibrations. M3x8 SHCS M3 Hammerhead Nut...
Page 25
DOORS WWW.VORONDESIGN.COM M3 Hammerhead Nut Magnets GLUE INTO PLACE Use a fast acting glue like super-glue. M3x8 SHCS Magnets MIND THE MAGNET POLARITY Ensure that the magnets are facing in the right direction prior to gluing them into place.
Page 30
EXHAUST WWW.VORONDESIGN.COM Heat Set Insert...
Page 31
EXHAUST WWW.VORONDESIGN.COM BSPP ADAPTER Some adapters have a small lip that prevents the PTFE tube from passing through. Inspect the adapter and if necessary use a drill to carefully remove the lip.
Page 39
Voron Documentation Welcome to the world of Voron 3D printers! This is the Voron Documentation site. All of the information needed to go from zero to a working Voron printer can be found here. If this is the first time building a Voron printer (especially if this is the first 3D printer), it is strongly suggested to build 100% to spec using the documentation provided here.
Need help?
Do you have a question about the VORON 2.4 KIT 9 and is the answer not in the manual?
Questions and answers