Page 1
All the rights to this manual are reserved, especially reproduction, publication and translation rights. No portion of this manual may be reproduced by no means (photocopy, microfilm or other methods) without previous written authorization from ECLERIS. Neither can it be reproduced, multiplied or published through any electronic data processing form.
USER MANUAL – PROCAM HD CMOS II TABLE OF CONTENTS SYMBOLS ..........................3 SAFETY INFORMATION ......................3 DESCRIPTION......................... 5 INTENDED USE ........................5 INTENDED USER ........................ 5 COMPONENTS ........................6 3.4.1 CONSOLE .......................... 6 3.4.2 PROCAM CAMERA ......................7 INSTALLATION........................7 REVISION ..........................
USER MANUAL – PROCAM HD CMOS II 1. SYMBOLS Read the related documentation CE Mark Manufacturer information Serial Number (Name, Address) Warning Caution Alternate current Applicable Part Type B Keep dry and protected from Do not discard with the humidity...
Page 4
ECLERIS office. ECLERIS will not be held responsible for damage that can occur to the equipment due to not following the instructions or not observing the following criteria: ...
USER MANUAL – PROCAM HD CMOS II Any use outside of the manufacturer specific intent use, will exclude ECLERIS of all liability. If by any of the following: Inadequate use of the equipment. Failure to use the instruction manual.
USER MANUAL – PROCAM HD CMOS II 3.4 COMPONENTS PROCAM HD includes the following components. Check and identify them before proceeding to the installation: Console (unit main) HD videocamera (handheld) Power cord HDMI cord Use video monitors certified under IEC60601.
Connect the connector of the video camera ECLERIS to the connector in the front panel. Plug the video output connector on the rear panel of the PROCAM HD console to the video input of the video monitor.
Do not sterilize the device. For use in the operating room use a sterile sheath. 1. Press the power button in front of the PROCAM HD console. The LEDs of the PROCAM HD camera will blink for few seconds and then they will turn off. It indicates that the PROCAM HD camera head is being powered.
USER MANUAL – PROCAM HD CMOS II 6. Once the procedure is over, turn the device off in order to maximize the system lifetime and energy saving. 5.1 CONSOLE FUNCTIONS 5.1.1 WHITE BALANCE To obtain the white balance, focus on a completely bright and white image lit with the maximum intensity and press the White Balance button for approximately 3 seconds.
USER MANUAL – PROCAM HD CMOS II The changes will be stored in the memory. 5.2 CAMERA FUNCTIONS 5.2.1 ZOOM FUNCTION The system has 10 levels of zoom: . . . Page 10 of 16 INMANUUIN153 Rev.2019.04.01 / ENG...
6. MAINTENANCE The following procedures are recommended to conserve PROCAM HD, in optimum working conditions: Before the maintenance of the PROCAM HD, disconnect the power cable from the device and from the electric power supply. Periodic cleaning of all external components.
3. Remove the damaged fuses and replace them with the spare fuses, to do this use the same value of the replaced fuses. Only use fuses as shown at the rear side of the PROCAM HD console and certified by IEC60127.
Page 13
USER MANUAL – PROCAM HD CMOS II DEGREE OF PROTECTION AGAINST HARMFUL ENTRY OF LIQUIDS AND IPX0 SOLIDS POWER CONSUMPTION 25 VA FUSES 2 x T2AL250V VIDEO OUTPUT HDMI, DVI, VGA, CVBS RESOLUTION 1920 (H) x 1080 (V) @ 60 fps 1/3”...
The following table indicates the most common problems and their solutions. Please consult this table if you have any inconvenience. As PROCAM HD console is always used in combination with a video monitor and a videocamera, faults will be analyzed considering the whole system.
ECLERIS state as repairable. ECLERIS will provide under request circuits, list of components, description calibration instructions or any other information in order to assist the ECLERIS authorized technical personnel.
The guarantee is for the term of one (1) year starting on the purchase date. ECLERIS shall not be responsible for damage caused by/to the PROCAM HD and its power supplies for inadequate use, neglect, incorrect cleaning or storage. Any repairs carried out by anyone other than ECLERIS authorized personal will annul this warranty.
Need help?
Do you have a question about the PROCAM HD and is the answer not in the manual?
Questions and answers