COOK TRE Installation, Operation And Maintenance Manual page 2

TRE Parts List
4
3
TRE Knockdown Installation Instructions
Top, bottom & cross braces
are bolted together
Tier Extrusion
"Detail" Top View
Limited Warranty
Loren Cook Company warrants that your Loren Cook fan was manufactured free of defects in materials and workmanship, to the extent stated herein.
For a period of five (5) years after date of shipment, we will replace any parts found to be defective without charge, except for shipping costs which will be
paid by you. This warranty is granted only to the original purchaser placing the fan in service. This warranty is void if the fan or any part thereof has been
altered or modified from its original design or has been abused, misused, damaged or is in worn condition or if the fan has been used other than for the
uses described in the company manual. This warranty does not cover defects resulting from normal wear and tear. To make a warranty claim, notify Loren
Cook Company, General Offices, 2015 East Dale Street, Springfield, Missouri 65803-4637, explaining in writing, in detail, your complaint and referring to
the specific model and serial numbers of your fan. Upon receipt by Loren Cook Company of your written complaint, you will be notified, within thirty (30)
days of our receipt of your complaint, in writing, as to the manner in which your claim will be handled. If you are entitled to warranty relief, a warranty ad-
justment will be completed within sixty (60) business days of the receipt of your written complaint by Loren Cook Company. This warranty gives only the
original purchaser placing the fan in service specifically the right. You may have other legal rights which vary from state to state.
TRE IO&M
Hood is bolted at
corners and braces
5/16" Nut & Bolt
(between each tier)
1/8" Aluminum Plate
Note: Center tier dividers can
vary in qty. Depending on size
of unit, tier material comes in
192" long sections
Corporate Offices: 2015 E. Dale St. Springfield, MO 65803
Phone 417-869-6474 | Fax 417-862-3820 | lorencook.com
Part No.
1
2
3
4
2
Topcaps can have multiple sec
tions depending on unit length
(some may be left assembled)
Braces on tiers
are welded on
2
Description
Topcap
Base
Corner Post
Tier
Bolt hood together
at each section
Tier Extrusion
5/16" Nut & Bolt
(between each tier)
1/8" Aluminum plate
March 2017
B51144-002