Attaching Mounting Frames To A Hard Disk - Epson Endeavor L User Manual

Depending on the type of drive you are installing, you may
need to attach mounting frames to it before you install it in a
horizontal bay. Follow these guidelines:
0 If you are installing a drive with a 5.25-inch form factor,
skip to "Installing the Drive" on page 5-17.
0 If you install a drive that has a 3.5-inch form factor, it must
have mounting frames to fit properly in the horizontal bay.
Follow the steps in the next section.
0 If you are installing a drive that already has mounting
frames on it, see if it also has a plastic guiderail and metal
grounding plate attached to it. If so, you'll need to replace
the plastic guiderail with the two metal guiderails that
came with your computer. Follow step 1 on page 5-4 to
remove the guiderail and grounding plate. Then go to
"Installing the Drive" on page 5-17.

Attaching Mounting Frames to a Hard Disk

To attach mounting frames to a hard disk drive, follow these
steps:
1. Locate the two mounting frames and the screws that came
with the drive.
Installing and Removing Drives
5 - 1 5