Using The Hot Key Feature - Epson Endeavor L User Manual

Using a Pass word
If you set a system access password in SETUP, you must enter
it every time you turn on or reset the computer. Follow these
steps to use your password:
1. If you do not have a hard disk, insert your system diskette
in drive A.
2. Turn on or reset the computer. You see the following prompt:
E n t e r P a s s w o r d :
Type your password and press Enter.
3.
After you type the password correctly and press Enter, the
computer loads the operating system and displays the
command prompt.
N o t e
If you do not know the correct password, see "Password
Problems" in Chapter 6.

Using the Hot Key Feature

If you have set a password, you can keep unauthorized users
from accessing your system by using the hot key feature. This
key combination (Ctrl Alt and the key of your choice)
temporarily locks your keyboard and mouse so you can secure
your system without turning it off.
To use the hot key feature, follow these steps:
1. See Chapter 2 to set your password and define a hot key.
Using Your Computer 3- 7