Option Card Problem - Epson Endeavor L User Manual

The printer prints garbled information.
Check the printer manual for the printer's correct DIP switch or
control panel settings.
Also, make sure you have the proper drivers installed for your
printer and make sure you've selected the correct printer
within your software application.
You see a port error message for the port your printer is
using.
You may need to identify primary and secondary ports in
SETUP. See Chapter 2 for instructions on how to set the parallel
and serial ports using the Peripherals Setup option in
SETUP.
Option Card Problems
A newly installed option card is not working correctly.
Make sure the option card is installed correctly and is
well-seated in its slot. Run the SETUP program to update your
computer's configuration after you install the card. Also,
perform setup procedures for any software you are using with
the option card.
See the documentation that came with the option card to set
any necessary DIP switches or jumpers on the card.
The computer may also have some jumpers that must be set for
the option card to work properly. See Chapter 4 for system
jumper information.
Your system may need to operate at the slower processor speed
to access the device. Try reducing the processor speed (see
Chapter 3).
Troubleshooting
6 - 1 1