Cover Over The Horizontal Carriage; Removing The Cover - Siemens ARCOSKOP Troubleshooting Manual

Prerequisites

Cover over the horizontal carriage

Fig. 6

Removing the cover

NOTE
•
Loosen the 6 mounting screws (1/Fig. 6).
CAUTION
•
Expand the cover at the rear end in the direction of the arrow (see Fig. 2) and remove it
downwards.
•
If needed disconnect the protective ground wire, the cable of the keypad (brake buttons)
and the cable of the emergency stop button.
Siemens AG
Medical Solutions
Fig. 6 and Fig. 7 are examples and show the cover of the SIREMO-
BIL Iso-C.
The cover of the ARCOSKOP horizontal carriage is open to the
front in the area of the verical lifting column and has no emer-
gency stop button and only 3 brake buttons.
However, the cover of the ARCOSKOP can be removed and atta-
ched in practically the same way.
Danger of injury when dismantling / assembling mechanical
parts! Non-compliance can lead to minor up to moderately severe
injuries, especially to the hands!
The cover over the horizontal carriage is bent U-shaped and must
be pulled on the side to the outside when it is removed.
The cover is then under mechanical stress.
We recommend that you wear light working gloves to avoid inju-
ries.
SPR2-250.840.01
Rev. 01
Fig. 7
Seite 9 von 16
09.05 CS PS 24
1 - 9
1
1
ARCOSKOP
System Manual