Controller Use - Argo APHPDHW200 Use And Installation Manual

8.2 Controller Use

NOTE: The setting and modification of parameters
protected by password can only be carried out by
qualified proffessionals.
Turn ON/OFF the unit
Press " " and hold for 0.5s in the standby interface
of the controller to turn on the unit and at this time the
main display area
temperature.
Timer setting
1) Under the standard mode, economic
intelligent mode, you can enter the timer setting.
Press " " and hold for 2s, the "ON" and "1" will
flash, and then you can set the turn-on time of timer1 as
the clock setting shows. After finishing, "OFF" and "1"
will flash, that means you can set the turn-off time of
timer1. The "ON" and "2" will flash after finishing the
timer1 setting, you can set the turn-on time of
timer2. After finishing, the "OFF" and "2" will flash, and
then you can set the turn-off time of timer2. Press "
again to save and to go back to the interface. If you
don't need to set the timer2, you can press the "
save after finishing the timer1 setting. You will find the
"ON" and "2" flash. With no operation for 5s, the
program will go back to the interface automatically.
52
shows the water outlet
mode,
Press " " and hold for 0.5s in the running interface
of the controller to turn off the unit and at this time
the main display area shows OFF.
Note: The ON/OFF button can only be used to turn
on/off the unit in standby or running interface of the
controller.
Note: When pressing "
"ON" and "1" will flash. It is
you to set the turn-on time of the timer1. You can
sequentially press "
of timer1. So does the timer2. Press "
circularly display.
Timer Cancel: Press "
into the interface, and then press "
all the operation. Please see the following picture
for more details.
"
" to
" and holding for 2s, the
not necessary for
" for 2s to enter the turn-off time
" or "
" and hold for 2s to enter
" to cancel
" to