Table of Contents
Advertisement
MAN
UAL
1
1 2 3
Ha rd Chill
-
4
20
7
1:30
The appliance works with infinite time.
When the cycle is active, it is possible to deactivate it by touching
the icon again.
Turbo cooling cycle can be activated also from the lower drawer.
(see paragraph LOWER DRAWER in chapter E.6 Drawers area).
In Hot and Holding cycles the pop-up window shows the infinite
icon
instead of Turbo cooling icon.
PROBE CYCLE
The core probe allows precise measurement of the exact core
temperature of the food during a cycle. This option excludes the
time cycle setting.
To set a probe cycle proceed as follow:
• Touch the time or probe icon in the main page and select the
CORE PROBE option;
MAN UAL
1
Chill
0
°C
Soft / Hard
01:30
:00
If a Reference Standard is selected, it is not possible to change
temperature parameters.
The end-of-cycle set is required by the reference standards; to
modify it, disable norms.
In case of a multiphase cycle, the Reference Standard is applied
only in the last phase. The intermediate phases can be modified.
• Touch the button
.
• Precooling (or preheating) starts.
• At the end of precooling (or preheating) open the door and
remove the food probe from its seat.
NOTE!
Make sure the core probe is cleaned and sterilised
when inserting it in the product.
18
Turbo
cooling
c
5
6
°
8
9
0
m:s
h:m
MAN
UAL
01:20
h:m
1
1 2 3
Ha rd Chill
c
-
4
20
5
6
°
7
8
9
1:30
0
h:m
h:m
m:s
• Insert the core probe in the product without forcing exces-
sively and close the door to start the cycle.
Make sure the tip (the sensitive part) is positioned. It is
important to place the core probe correctly near the center of
the product, making sure the tip does not protrude and, in
particular, that it does not touch the pan.
OK!
If the core probe is not inserted or is inserted wrongly, after
some minutes a pop-up window opens showing the message
the cycle is going to be driven by time in order to not corrupt
the process.
MAN
UAL
The probe is not inserted. The
cycle automatically changed
MAN
UAL
01:20
1
• At the end of the cycle, open the door and remove the core
probe, putting it back in its original position.
1 2 3
Ha rd Chill
4
-
7
b
1:30
NOTE!
Remember that the pans are cold, therefore use
gloves
PRODUCT LOADING
USER
i
Probe not inserted
from probe to time.
USER
c
5
a
6
°
20
8
9
0
m:s
h:m
Advertisement
Table of Contents
