Characteristics Of Power Supply Cable; Characteristics Of Power Supply; Etransport, Handling And Storage; Introduction - Electrolux ELAI3 Series Installation Manual

Model
Standard cycle
time with water
sec.
supply at 50℃
4
[122℉].
Legal noise level
dB(A)
6
Leq
Protection rating
Power supply cable
1. If activated by software, coincidence of tank and boiler heating elements.
2. Only for model ELAI3WGML
3. Disinfection cycle.
4. Standard cycle time may vary should the inlet water temperature and/or the boiler heating elements be different from that indicated above.
5. Only for model VUCA060
6. The noise emission values have been obtained according to EN ISO 11204.
D.3

Characteristics of power supply cable

400 - 440V 3~
C
5.35 kW 4x2,5 mm 2
6.85 kW 4x2,5 mm 2
7.35 kW 4x2,5 mm 2
8.85 kW 4x2,5 mm 2
9.35 kW 4x2,5 mm 2
11.85 kW 4 4 mm 2
C = Power supply cable
S = On/Off switch
D.4

Characteristics of power supply

The AC power supply to the machine must meet the following conditions:
• max. voltage variation ± 6%
• max. frequency variation ± 1% continuous ± 2% for a short period.
Harmonic distorsion, unbalanced three-phase supply voltage, voltage pulses, interruption, dips and the other electric character-
istics must respect the provisions of point 4.3.2 of Standard EN 60204-1 (IEC 60204-1).
E TRANSPORT, HANDLING AND STORAGE
WARNING
Refer to "Safety Information".
E.1

Introduction

Transport (i. e. transfer of the appliance from one place to
another) and handling (i. e. transfer inside workplaces) must
occur with the use of special and adequate means.
CAUTION
The appliance must only be transported, handled and
stored by specialised personnel, who must have:
• specific technical training and experience in the use of
lifting systems;
• knowledge of the safety regulations and applicable laws
in the relevant sectors;
• knowledge of the general safety rules;
• personal protection equipment suitable for the type of
operation carried out;
• the ability to recognize and avoid any possible hazard.
16
ELAI3GTL ELAI3GCL
90 - 120 - 90 - 120 -
240 240
380 - 415V 3~N
S C
16A 3P 5x2,5 mm 2 16A 3P + N
16A 3P 5x2,5 mm 2 16A 3P + N
16A 3P 5x2,5 mm 2 16A 3P + N
16A 3P 5x2,5 mm 2 16A 3P + N
20A 3P 5x2,5 mm 2 20A 3P + N
32A 3P 5x4 mm 2 25A 3P + N
EUCA060
VUCA060
ELAI3GWL ZUCA060
ELAI3PML
ELAI3WGML
90 - 120 - 240
90 - 113 - 173
[90 - 240]
LpA: 61dB - KpA: 1.5dB
IPX4
H07RN-F
220 - 240V 3~
S C
4x4 mm 2 20A 3P
4x4 mm 2 20A 3P
4x4 mm 2 25A 3P
4x4 mm 2 32A 3P
4x6 mm 2 32A 3P
4x8 mm 2 40A 3P
E.2

Transport: Instructions for the carrier

IMPORTANT
The transported load can shift:
• when braking;
• when accelerating;
• in corners;
• on rough roads.
E.3

Handling

Arrange a suitable area with flat floor for appliance unloading
and storage operations.
E.3.1

Procedures for handling operations

Before lifting:
• send all operators to a safe position and prevent persons
from entering the handling area;
• make sure the load is stable;
• make sure no material can fall during lifting. Manoeuvre
vertically in order to avoid impacts;
• handle the appliance, keeping it at minimum height from the
ground.
ET5AI ET5AIP
3
90 - 120 -
90 - 120 - 120
5
120
220 - 240V 1~N
S C
3x6 mm 2 30A 1P + N
3x6 mm 2 40A 1P + N
3x10 mm 2 40A 1P + N
3x10 mm 2 50A 1P + N
3x10 mm 2 50A 1P + N
3x16 mm 2 63A 1P + N
S