Cgeneral Information; Introduction; Definitions; Machine And Manufacturer's Identification Data - Electrolux ELAI3 Series Installation Manual

• BEFORE SERVICING, DISCONNECT THE ELECTRICAL SERVICE AND PLACE A
RED TAG AT THE DISCONNECT SWITCH TO INDICATE WORK IS BEING DONE ON
THAT CIRCUIT.
NOTE!
• Contact your authorized service company to perform maintenance and repairs.
• Using any parts other than genuine factory manufactured parts relieves the
manufacturer of all warranty and liability.
• Manufacturer reserves the right to change specifications at any time without
notice.
WARNING
• The equipment warranty is not valid unless the appliance is installed,
started and demonstrated under the supervision of a factory trained
installer.
• The unit must be installed by Personnel who are qualified to work with
electricity and plumbing. Improper installation can cause injury to person-
nel and/or damage to the equipment.
• The unit must be installed in accordance with all National Codes governing
plumbing, sanitation, safety and good trade practices.
C GENERAL INFORMATION
C.1

Introduction

The drawings and diagrams given in the manual are not in
scale. They supplement the written information with an outline,
but are not intended to be a detailed representation of the
appliance supplied.
The numerical values given on the appliance installation
diagrams refer to measurements in millimeters and/or inches.
C.2

Definitions

Listed below are the definitions of the main terms used in the
manual. It is advisable to read them carefully before use.
Operator machine installation, adjustment, use,
maintenance, cleaning, repair and trans-
port personnel.
Manufacturer Electrolux Professional SpA or any other
service centre authorised by Electrolux
Professional SpA.
Operator for an operator who has been informed and
normal trained regarding the tasks and hazards
machine use involved in normal machine use.
Customer an operator instructed/trained by the
Care service Manufacturer and who, based on his
or specialised professional and specific training, experi-
technician ence and knowledge of the accident-
prevention regulations, is able to appraise
the operations to be carried out on the
machine and recognise and prevent any
risks. His professionalism covers the
mechanical, electrotechnical and elec-
tronics fields.
Danger source of possible injury or harm to health.
Hazardous any situation where an operator is
situation exposed to one or more hazards.
Risk a combination of probabilities and risks of
injury or harm to health in a hazardous
situation.
SAVE THESE INSTRUCTIONS
Protection
devices
Guard
Safety device
Customer
Emergency
stop device
Electrocution
C.3
A reproduction of the marking or dataplate on the machine is
given below:
F.Mod.
PNC
EL
Type ref.
The dataplate gives the product identification and technical data;
listed below is the meaning of the various information given on it.
safety measures consisting of the use of
specific technical means (guards and
safety devices) for protecting operators
against risks.
an element of a machine used in a specific
way to provide protection by means of a
physical barrier.
a device (other than a guard) that elimi-
nates or reduces the risk; it can be used
alone or in combination with a guard.
the person who purchased the machine
and/or who manages and uses it (e. g.
company, entrepreneur, firm).
a group of components intended for the
emergency stop function; the device is
activated with a single action and pre-
vents or reduces damage to persons/
machines/property/animals.
an accidental discharge of electric current
on a human body.
Machine and Manufacturer's
identification data
Electrolux Professional spa - Viale Treviso, 15 - 33170 Pordenone (Italy)
2017
Comm. Model:
Ser.Nr.
Hz Max 12.9 kW
Nominal 9.9 kW
Min
6.9 kW
IP
11