Troubleshooting - Westfalia AHP 18 Original Instructions Manual

Problem
Red and green LEDs
do not illuminate to
indicate the battery is
charging correctly
Battery pack has low
capacity
Trigger switch (8)
does not move
Device does not start
when trigger switch is
depressed

Troubleshooting

Possible Cause
Battery not correctly
connected to charger
Charger not powered
Battery not being
fully charged
Battery pack has
been charged over
100 times and capac-
ity has started to re-
duce
The safety switch is
in the "locked" posi-
tion
Battery completely
discharged
Defective battery
Tool defective
21
Solution
Clean battery socket
of charger and bat-
tery contacts and
fully slide on to
charger so it clicks in
a locked position
Recheck mains con-
nection
Do not remove bat-
tery until a full charge
is indicated
This is normal for
battery packs. Con-
tact Westfalia pur-
chase a replacement
battery pack
Slide the safety
switch either to the
left or right
Recharge battery or
replace with a fully
charged battery
Replace battery
Contact the West-
falia customer ser-
vice