Table of Contents
Advertisement
The machine
cannot be
switched on
The machine
cuts out when
idling
The machine
cuts out when
planing
Loss of speed
when planing:
Poor surface
quality on the
machined
workpiece
Chip discharge
for surfacing or
thicknessing
blocked
Uneven feed
speed for
thicknessing
Troubleshooting
No mains power. Check the power supply.
Carbon brushes worn. Have the carbon brushes
replaced by an electrician.
Power failure (check fuses). Have the fuse
replaced by an electrician.
Blunt knife or feed speed too high. Replace the
knife or reduce the feed speed.
Cutting depth is too deep. Reduce cutting depth.
Feed speed too high. Reduce feed speed.
Blunt knife. Replace knife.
Blunt knife. Replace knife.
Uneven feed. Feed the workpiece at constant
pressure and reduced feed speed.
Dust extraction system not connected. Connect
dust extraction system.
Dust extraction system not connected. Connect
dust extraction system.
Wood too wet.
Rubber belt is too loose. Check rubber belt and
replace if necessary.
Thicknessing table soiled. Clean the thicknessing
table and treat with a lubricant if necessary.
37
Advertisement
Table of Contents
