Installing The Processor And Heat Sink - TYAN GC68A-B8056 Service Engineer's Manual

4.6

Installing the Processor and Heat sink

The S8056 supported AMD
http://www.tyan.com
NOTE: MITAC TYAN is not liable for damage as a result of operating an
unsupported configuration.
Processor Installation (Single Socket / for AMD
Follow the steps below to install the processors and heat sinks.
Please note that the illustrations are based on socket which may not look exactly like
the motherboard you purchased. Therefore, the illustrations should be held for your
reference only.
NOTE: Please save and replace the flip CPU protection cap when returning for
service.
1. Use a T20 Torx screwdriver to loosen the screws securing the force frame.
NOTE: The force frame will automatically eject after the captive screws are
being released.
2. By placing your both index fingers on the sides on the metal handle, pull to
release the rail frame. Then lift the rail frame to its fully open position.
® processors are listed in Section. Check our website at
for latest processor support.
http://www.tyan.com
EPYC™ 9004 Series CPU)
®
92