Mercury Avator 7.5e Operation, Maintenance And Installation Manual page 48

This product must be secured to the transom with the required mounting
hardware. If the outboard strikes an underwater object, the required mounting
hardware prevents the outboard from propelling off the transom. A decal on the
swivel bracket reminds the installer of the potential hazard.
IMPORTANT: Do not use the transom assembly of the outboard to guide
the drill. Use the included template to mark the holes and if a drill fixture is
required, use the drill fixture specific to Avator 7.5e.
1. Place the template or drill fixture on the boat's transom, paying special
attention to the centerline guide and the folded top of the template.
2. With the transom template, part number 8M0182092, mark where the
lower 9 mm (3/8 in.) holes in the boat's transom will be drilled.
INSTALLATION
38
75272
eng