Wheel Bolt Cover Caps; Full Wheel Frame - Volkswagen Taigun 2022 Owner's Manual

— Follow the instructions on the screen.
When the tyre pressure needs to be saved
Save the tyre pressures in the following cases:
— Change of tyre pressure
— Change of one or more wheels
— Change of position of a wheel on the vehicle
— Always after 10,000 km or once a year
Sticker for storing tyre pressure readings
The process for storing tyre pressures is also shown
on a label on the central body pillar on the driver's
side.
Inflating the tyres to the specified pressure
1
Saving the values
2
Troubleshooting
Restricted function / system fault
flashes approx. 1minute and then remains il-
luminated
— Stop the vehicle, switch off the ignition and start
the engine.
If the indicator light flashes again after starting
the engine there is a fault in the system.
— Continue driving, exercising appropriate caution,
and seek assistance from a specialist garage.

Wheel bolt cover caps

Removing and installing bolt caps
Removing
— Insert the extraction pliers from the tool kit into
the hole in the bolt cap.
— Remove the cover cap.
Installing
— Push the cover cap onto the wheel bolt to the
stop.

Full wheel frame

Removing and installing the trim
Applies to factory built or Volkswagen Genuine Ac-
cessories trims.
Removing
— Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
— Push the wheelbrace through the clamp, push on
the tyre and pull off the wheel trim.
Installing
— Press the wheel trim onto the wheel rim at the
designated valve opening.
When using an anti-theft wheel bolt, it must be
located as shown on the bezel.
— Press the trim, starting at the valve, into the rim
on both sides until it engages around the entire
circumference.
NOTICE
·
Use hand pressure, do not hit the wheel cover.
Wheel bolt cover caps 119