Transducer Interface - norbar TTT 3 Series Operator's Handbook Manual

Torque tool tester

Hide thumbs

Table Of Contents

Table of Contents

TTT SERIES 3 OPERATORS HANDBOOK

INTRODUCTION:- ____________________________________________________________

The 3 transducer connectors are designed for use with most four wire bridge strain gauge type

transducers.

When used with Norbar 'SMART' transducers the calibration data will be automatically known.

For 'NON-SMART' transducers up to 20 sets of transducer parameters can be stored in the TTT

for ease of use. These can be configured with USER units.

TIP. Mark 'NON-SMART' transducers with their stored 'T' number for ease of identification.

Ensure transducer selection switch is in the correct position for the transducer in use. See the

TD#1, TD#2 & TD#3 symbols next to transducer connectors.

TIP. Press '#' in track mode to show details of transducer in use.

TIP. If any of the transducer's parameters are changed i.e. re-calibration of mV/V value, the

transducer's stored parameters must be edited prior to use. ('NON-SMART' only).

Norbar transducers with the following suffix are all suitable for use with the TTT:

Suffix

Description

XXXXX.IND

'SMART' transducer calibrated in mV/V.

XXXXX.INDA

'SMART' transducer with integral angle encoder calibrated in mV/V.

XXXXX.LOG

'SMART' transducer calibrated with a TTT in units of calibration.

A mV/V figure is also supplied.

XXXXX.LOGA

'SMART' transducer with integral angle encoder calibrated with a TTT in

units of calibration. A mV/V figure is also supplied.

NOTE: - Transducers supplied for use with the Pro-Log are compatible with the TTT.

The TTT will not display angle when interfaced to a .INDA or .LOGA transducer.

ETS Transducers supplied with an amplifier module will need to be modified for use

with the TTT.

TRANSDUCER LEADS AVAILABLE:-_____________________________________________

Part Number

60216.200

60217.200

60223.200

NOTE: - The suffix after the part number indicates the length of the lead in cm, thus

XXXXX.200 = 2 metres. If Transducer leads are required of a non-standard length, the

new suffix must be added to the part number when ordering (to the nearest metre).