Assembly Instructions; Assembly Of Transducer Plate To Stand; Assembly Of Loading Device To Stand - norbar TWL 1500 Operator's Handbook Manual

ASSEMBLY INSTRUCTIONS

A. ASSEMBLY OF TRANSDUCER PLATE TO STAND
1) Align flanges of transducer plate and use the frame assembly bolt kit (M10 bolts,
washers and nuts) to fasten.
2) Tighten bolts to 20 N.m.
TRANSDUCER
PLATE
B. ASSEMBLY OF LOADING DEVICE TO STAND
1) Remove the 2 thumb screws and the clamp plate from the loading device.
2) Position the loading device onto the stand ensuring that the hand wheel is on the
side of the operator
3) Reconnect the clamp plate using the 2 thumb screws and tighten in the desired
position along the stand.
4) Screw the handle to the hand wheel and tighten the locknut
5) Slide the support bobbin onto the reaction post
SUPPORT
BOBBIN
THUMB
SCREWS
LOADING DEVICE
PAGE 4 OF 8
Issue 2
JANUARY 2005
STAND
HAND WHEEL
HANDLE
CLAMP PLATE