Sony DSC-1024HD Instructions Manual page 16

MENU button
You can store the parameters of the adjusted picture into
memory. Five sets of input/output selection, zooming size,
H/V size and H/V position can be stored into memory and
switched quickly.
Up to 5 memories are available.
Storing the current condition
1 Adjust the picture as necessary.
2 Press the MENU button.
The MENU 1 screen appears.
MENU
Press the CENT button to move the cursor
MEM SAVE, and press the ENTER button.
The MEM SAVE screen appears.
The current data is displayed on the left column under
"CURRENT" and the data in the memory on the right
column. If no data is stored in the memory, that item is
shown by
ENTER
CENT
Press the CENT button repeatedly so that the
desired memory number (1 to 5) appears.
40
ENTER button buttons
CENT
to
Current data
Memory number
5 Press the ENTER button.
The current data is stored under the selected memory
number on the right column.
If any data has been stored in the selected memory
number, it is now displayed on the left column under
"CURRENT."
ENTER
6 To quit the menu, press the MENU button three times.
Calling up the stored data
Press the MENU button.
1
The MENU 1 screen appears.
2 Press the CENT button to move the cursor
MEM LOAD, and press the ENTER button.
The MEM LOAD menu appears.
3 Press the CENT button repeatedly to select the
desired memory number (1 to 5), and press the ENTER
button.
The converter is adjusted to the selected memory data.
4 To cancel the operation, press the MENU button twice.
To call up the stored data quickly
Use the remote commander. See "Direct memory loading" on
page 42.
Current data stored
to