Sony DSC-1024HD Instructions Manual page 10

Before you get started
• First make sure that the power to each piece of equipment is
turned off.
• Use connecting cables suitable for the equipment to be
connected.
• The cable connectors should be fully inserted into the jacks.
A loose connection may cause hum and other noise.
The following diagram shows a connection example to convert a low-rate input signal into a high-rate output signal.
VCR, laser disc player,
game machine, etc.
S VIDEG
OUT
VIDEO 1 IN
Y / C I N
Computer monitor (VGA or SVGA),
etc.
Setting the VIDEO OUT selectors
• Set the RGB/YBR selector to RGB (when a computer
monitor, data projector or LCD projector is connected).
• Set the SYNC selector to SEP (HD or VD separate sync) or
COMP (composite sync) depending on the connected
equipment.
34
CONTROL
AUDIO
OUT L/R SOUT
VIDEO 3 IN
VIDEO 3 IN selectors
R/G/B/HD/VD IN
• To disconnect the cable, pull out by grasping the plug.
Never pull the cable itself.
• Read the instruction manual of the equipment to be
connected.
Betacam SP video cassette
recorder
AUDIO IN
AUDIO 1 L/R
VIDEO OUT selectors
VIDEO OUT
Data projector, LCD projector,
etc.
When the Betacam SP video cassette recorder is
connected to VIDEO 3 IN
Set the VIDEO 3 IN selectors as follows:
• 75 /OPEN selector
• RGB/YBR selector YBR
• SYNC selector
Connect only the three plugs of the signal cable to the Betacam
SP video cassette recorder: green plug to Y connector, red to R-
Y, and blue to B-Y. Leave the other plugs, if provided,
disconnected.
AUDIO OUT L/R
COMPONENT
(Y, R-Y, B-Y)
AUDIO IN
AUDIO 3
L/R
CTRL S IN
OUT L/R
AUDIO IN
L/R
Public announcement
system, etc
AUTO
AC IN
AC power cord
to a wall outlet