Sony DSC-1024HD Instructions Manual page 18

This unit accepts wireless or wired remote commanders for
Sony monitors, TVs and projectors.
Setting the type of the remote commander
Set the COMMAND MODE selector according to the type of
the remote commander.
TV: Sony monitors' or TVs'
commander
PJ: Sony projectors' commander
OFF: When not using the remote
commandder, set to this
position to avoid malfunction.
Available remote commander operations
The following operations can be controlled by the remote
commander.
Power on/off
Input selection
Picture adjustments: contrast, phase and chroma
On-screen display on/off (only for video monitors and TVs)
Menu operations (See the right column.)
Direct memory loading (See the right column.)
The available operations and the buttons to be used for each
operation are limited depending on each remote commander.
See the table below.
COMMAND MODE setting
Input selection INPUT SELECT 1
INPUT SELECT 2
INPUT SELECT 3
Menu operation MENU
ENTER
Picture adjustment
42
COMMAND MODE selector
TV
LINE1
LINE2
LINE3
CONTRAST
CHROMA
PHASE
Remote sensor
Direct memory loading
The remote commander can quickly call up the adjustment
data stored in the memory.
Press buttons 7, 7, 7 and ENTER on the remote
1
commander in sequence at intervals of one second.
The "MEMORY LOAD READY" appears on the screen.
Select the memory number (1 to 5) you want to call up
2
using the number button.
The converter is adjusted to the selected memory data.
To cancel the operation
Press buttons 0, 0,0 and ENTER on the remote commander in
sequence at intervals of one second. The "MEMORY LOAD
EXIT" appears on the screen.
The direct memory load operation is also cancelled by turning
off the unit.
Be sure to press buttons 7,7,7 and ENTER, or 0,0,0 and
ENTER at intervals of about one second.
If more than 3 seconds elapse between two presses, the
operation will be cancelled. In this case, start again.
Menu operation using the remote commander
The menu screens for the remote commander are different
from those for the main unit.
When you press the menu button (MENU, PAGE or
remote commander once or twice, the GEOM MENU or
COLOR MENU appears respectively.
Select the item with the
(ENTER, or M SEL) on the remote commander. Then
adjust the selected item using the
PJ
PJ
VIDEO VIDEO
A A
B B
CONTR CONTR
COLOR
COLOR
HUE HUE
button and press the enter button
button.
PJ
PJ
1
VIDEOl
VIDE02 2
RGB 3
CONTR CONTR
COLOR -
HUE
-
on the