Sony DSC-1024HD Instructions Manual page 21

Connection example
Remote signal
When you construct a projection wall which displays a larger
picture constructed from multiple projectors, use the
converters as in the connection example above. Prepare one
converter for each projector.
Adjust the picture of each projector so that the projection wall
picture is displayed smoothly, and store the adjustment data
on each converter under the same memory number. This
enables you to quickly switch between a total of five projection
wall pictures.
Storing the adjustment data of the picture
1 Adjust the projectors.
Use the test patterns (HATCH, COLOR BAR and GRAY
SCALE) contained in the converter. For the test patterns,
see page 41.
2 Adjust pieces of the picture with the converter.
Set the zooming magnification according to the number of
pieces of the picture. Then adjust each piece of the picture
using the H/V SIZE buttons and CENT buttons so that
they connect smoothly as a large picture.
Number of pieces of the picture
4
9
16
For zooming and resizing the picture, see page 39.
3 Store the adjustment data in the memory of the
converter.
Store the data under the same memory number on each
converter.
For details, see "Storing the current condition" on page 40.
4 Repeat steps 1 to 3 for storing other picture patterns.
The adjustment data for up to five picture patterns can be
stored under memory numbers 1 to 5.
VIDEO OUT
Projection wall
VIDEO OUT
VIDEO OUT
VIDEO OUT
Zooming
x 2
x 3
x 4
Loop-through output
Loop-through output
VIDEO IN
Displaying the picture on the projection wall
The names of the remote commander buttons differ depending
on the commander model. Refer to the table on page 42.
1 Press buttons 7, 7, 7 and ENTER on the remote
commander in sequence at intervals of one second.
"MEMORY LOAD READY" appears on each projector
screen.
2 Select the memory number under which the adjustment
data of the desired picture pattern is stored by pressing
the number button.
All of the pieces of the picture are displayed properly so
that they connect smoothly as a large picture.
To switch to another picture pattern, press the number
3
button corresponding to the memory number.
CTRL S IN
CTRL S OUT
CTRL S IN
CTRL S OUT
CTRL S IN
CTRL S OUT
Remote
commander
45