Ep1957 Parameters; Fig. 23 Linking Tab - Beckhoff EP1957-0022 Operating Instructions Manual

5.3.6

EP1957 parameters

After creating the alias device, it can be parameterized according to the user specifications. The FSoE
address is set under the Linking tab, and the link to the physical device is created.
Fig. 23: Linking tab
Name
FSoE address
External safe address
Linking mode
Physical device
DIP switch
Input: Full Name
Input: Linked to:
Output: Full Name
Output: Linked to
Name
Under the Connection tab you can make further settings, e.g. the mapping of the info data or the behavior in
case of a module error.
EP1957-0022 and EP1957-2222
Description
Parameterized FSoE address (to be set by the user)
currently not supported
• Automatic (automatic linking to the physical device)
• Manual (manual linking, e.g. to network variables)
• Local (signals are used in the local logic)
Link to the TwinSAFE component within the TwinCAT solution
DIP or rotary switch address read from the TwinSAFE component
In manual mode:
Display of the variables below the TwinSAFE Logic, e.g. EL6910
In manual mode:
display of the linked variables
In manual mode:
Display of the variables below the TwinSAFE Logic, e.g. EL6910
In manual mode:
display of the linked variables
In manual mode:
name of the TwinSAFE message below the TwinSAFE Logic and for the info data
Version: 2.0.0
Operation
37