Pause In Spraying - Graco QuickShot 20B473 Owner's Manual

NOTE: The Cup Lid hooks onto the sprayer
while refilling the Cup.
4. Remove the Pump Filter and clean
debris from the filter screen.
5. Reinstall Pump Filter in the bottom of the
Cup.
6. Refill the Cup with paint and reinstall
Cup Lid.
7. Follow Startup instructions, page 14, to
proceed.
3A9301C

Pause in Spraying

Paint will dry quickly and cause clogs in the
sprayer. Follow these steps whenever you
pause spraying for 5 minutes to 2 hours.
1. Engage Trigger Lock and remove
Battery from sprayer.
2. Turn Prime Knob up to PRIME position
to relieve system pressure.
3. Turn Spray Tip 90 degrees to seal orifice
from drying out.
4. Close Storage Plug in Cup Lid to seal
material in Cup.
NOTICE
To avoid damage, never immerse the
electronic Spray Gun in water or other fluid.
Spraying
21