Notes On Safety; Symbols And Icons - Parkside PMNF 1500 A1 Translation Of The Original Instructions

GB
Cutting disc (included):
Idling speed n ............. max.12250 min
0
Disc speed ....................... max. 80 m/s*
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22,23 mm
*
The grinding disc must keep a rotational
speed of 80 m/s.
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
The vibration emission value has been
measured according to a standardised test-
ing method and may be used for compari-
son with another electric tool.
The indicated vibration emission value may
also be used for an introductory assess-
ment of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool
may vary from the given values in-
dependently of the type and way in
which the electric tool is used.
Try to keep the exposure to vibra-
tions­as­low­as­possible.­Examples­
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but­running­without­any­load).
24

Notes on safety

-1
Caution! When using power tools,
observe the following basic safety
measures for the prevention of
electric shocks and the risk of injury
and­fire.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.

Symbols and icons

Symbols on the device:
Warning!
­ Warning!­Electric­shock­hazard.
Always unplug the device before
working on it.
Read the manual!
Wear eye and ear protection.
Wear breathing protection.
Risk of cuts!
Wear­cut-resistant­gloves.
Wear safety shoes.
Do not use for wet grinding.
Safety class II
(Double­insulation).
­ Electrical­machines­do­not­belong­
with domestic waste.
Working direction