Complete Parameter List Table - andrews MAXXflo EVO CWH 30/201 Operating Instructions Manual

4.5 COMPLETE PARAMETER LIST TABLE

PARAMETER DESCRIPTION
Time of day and date
1 Time & Date
5 Start of summertime
6 End of summertime
Operator section
20 Language
40 Used as
42 Assignment device 1
44 Operation zone 2
46 Operation zone 3
48 Warmer / cooler device 1
70 Software version
Time program 4 (water heater)
Set time program
576 Default values
Time program 5 (Q4 secondary return pump)
Set time program
616 Default values
dHW
1600 DHW operating mode
1610 Nominal setpoint
1612 Reduced setpoint
Example:
Engineer
FACTORY NOTES
DEFAULT
- Current time and date settings. These settings can be
changed.
- Date of start for British Summer Time. An automatic one
hour adjustment will be made at 01:00 on this date. Please
remember that this date changes by a few days every year, so
adjustment of these dates at the start of the year is recom-
mended.
- Date of start for British Winter Time. An automatic one hour
adjustment will be made at 01:00 on this date. Please re-
member that this date changes by a few days every year, so
adjustment of these dates at the start of the year is recom-
mended.
English Change languages if required
Operator unit 1 Operator unit 1 only should be set
- Has no effect on DHW operation
- Has no effect on DHW operation
- Has no effect on DHW operation
- Has no effect on DHW operation
- Current firmware version for this Graphical User Interface
(GUI)
Optimised for Used to set the time program for DHW heating (can also be
BS EN 13302-1 set on the DHW water heater menu of the user screen) Follow
section 2.3 for instruction on how to set the time clock.
06:00 - 22:00 Reverts time clock settings to default values
daily
24 hours every Used to set the time program for DHW secondary return. Fol-
day low section 2.3 for instruction on how to set the time clock.
06:00 - 22:00 Reverts time clock settings to default values
daily
- On or Standby (operation via switch on front of heater)
57 C - 60 C Normal DHW set point (setpoint when activated within pro-
O O
gram 4 times) - Up to Max of 65
10 C This reduced temperature setpoint is active when the current
O
Optimised for time is outside the water heating time program settings (time
EN13302-1 program 4).
1612 1610 Max setting
37
C
o
MAXXflo EVO