Section 4: Operations; Operation Overview - Grizzly T33307 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide
the novice machine operator with a basic
understanding of how the tool is used
during operation, so the tool controls/com-
ponents discussed later in this manual are
easier to understand.
Due to the generic nature of this overview,
it is not intended to be an instructional
guide. To learn more about specific opera-
tions, read this entire manual, seek addi-
tional training from experienced machine
operators, and do additional research out-
side of this manual by reading "how-to"
books, trade magazines, or websites.
To reduce your risk of
serious
this
BEFORE using tool.
Eye injuries, respiratory problems,
or hearing loss can occur while
operating this tool. Wear person-
al protective equipment to reduce
your risk from these hazards.
Model T33307 (Mfd. Since 06/22)
injury, read
entire manual
To complete a typical operation, the
operator does the following:
1. Examines workpiece to make sure it is
suitable for planing.
2. Secures workpiece.
3. Adjusts cutting depth.
4. Installs fence if edge planing or fence
and depth gauge if rabbeting.
5. Puts on safety glasses, hearing
protection, and respirator.
6. Places tool on workpiece without
cutterhead contacting workpiece.
7. Starts tool.
8. Waits for cutterhead to reach full
speed, then moves tool forward to
plane workpiece.
9. Once cut is complete, stops tool,
allows cutterhead to come to complete
stop, then lifts tool.
10. Repeats Steps 6–9 until desired result
is achieved.
If you are not experienced with this
type of machine, WE STRONGLY
RECOMMEND that you seek addi-
tional training outside of this man-
ual. Read books/magazines or get
formal training before beginning any
projects. Regardless of the content
in this section, Grizzly Industrial
will not be held liable for accidents
caused by lack of training.
-11
-