Dust Collection - Grizzly T33307 Owner's Manual

Inventory
The following is a list of items shipped
with your tool. Before beginning setup, lay
these items out and inventory them.
If any non-proprietary parts are missing
(e.g. a nut or a washer), we will gladly
replace them; or for the sake of expediency,
replacements can be obtained at your
local hardware store.
If you cannot find an item on this
list, carefully check around/inside
the tool and packaging materials.
Often, these items get lost in pack-
aging materials while unpacking or
they are pre-installed at the factory.
Loose Inventory (Figure 1)
A. Fence .................................................1
B. Fence Mounting Bracket ....................1
C. Depth Gauge ......................................1
D. Fence Lock Knob ...............................1
E. Depth Gauge Lock Knob ...................1
F. Fence Scale Lock Knob .....................1
G. Fence Scale Lock Screw ...................1
A
D E
Figure 1. Loose inventory.
-8
-
The Model T33307 is equipped with a 1
dust port that can attach to a dust collec-
tion system or shop vacuum.
To connect to dust collection system:
1. Fit 1
Qty
2. Flip dust port selector so that chips
B
C
F
G
3. Tug hose to make sure it does not

Dust Collection

This tool creates a lot of wood chips/
dust during operation. Breathing
airborne dust on a regular basis can
result in permanent respiratory ill-
ness. Reduce your risk by wearing
a respirator and capturing the dust
with a dust-collection system.
⁄ " dust hose over dust port (see
1
2
Figure 2) and secure in place with
hose clamp.
only eject on side where dust collection
system is installed (see Figure 2).
Dust Port
Selector
Figure 2. Dust collection installed.
come off.
Note: A tight fit is necessary for proper
performance.
Model T33307 (Mfd. Since 06/22)
⁄ "
1
2
Dust
Hose