Safety Device; Fappliance Set Up; Introduction; Touch Models - Electrolux SkyLine PremiumS 6GN2/1 Installation Manual

6. Connect the wires to the terminal block as shown in the
following figure.
6–10 GN models
20 GN models
F APPLIANCE SET UP
F.1

Introduction

CAUTION
Make sure the appliance is connected to
the water supply, the draining system, the
power supply and, in case of gas model, to
the gas supply and to a exhaust burnt gas
system.
CAUTION
Check the correct working of the door
closing mechanism when the oven is hot.
It may be requested to adjust the position
of the door catch.
F.1.1

Touch models

When you start your new appliance for the first time, you are
prompted for an automatic set-up procedure, called Wizard,
once.
The appliance checks if all the installation steps have been
carried out correctly and performs a series of auto tests. The
Wizard lasts about ca. 30 minutes.
This procedure must be completed to guarantee the oven
performances and to allow its use.
IMPORTANT
This setup is meant to be carried out ONLY by an
authorized technician.
DANGER
Risk of fire! Before running the
wizard remove all packaging and
any items from the cavity.
30
7. After connection secure the cable screwing the cable
gland ring.
8. Fix the external box under the oven doing the corre-
sponding screw (if applicable in your model);
E.6.3

Safety device

The appliance is equipped with the following safety devices:
• Fuse - located behind the control panel.
For electrical models
• Cavity manual-reset safety thermostat - located behind the
control panel;
It switches off the electrical supply to the cavity heaters.
• Steam generator manual-reset safety thermostat - located
behind the control panel;
It switches off the electrical supply to the generator heaters.
• Automatic-reset thermal device inside the fan.
It activates if the fan overheats, protecting unit operation
and cuts off the electrical power to the appliance.
NOTE!
Resetting operations must be carried out by speci-
alised technical personnel after eliminating the
causes of interruption.
CAUTION
During operation, pay attention to the hot
areas of the exterior surface.
Do not place objects on the outlets located
at the back top of the appliance.
F.1.2

Digital models

When the oven is installed it is necessary to verify its correct
functionality by carrying out a series of cycles with the following
sequence:
boiler models
1. a cleaning cycle to check the hydraulic system sealing;
2. a steam cooking cycle to check the door gasket sealing;
3. a convection cooking cycle to check the temperature
achievement of 250 ℃ in the cavity.
boilerless models
1. a cleaning cycle to check the hydraulic system sealing;
2. a convection cooking cycle to check the temperature
achievement of 250 ℃ in the cavity.
NOTE!
For detailed information about the above proce-
dures consult the corresponding Service Manual.
F.2

WIZARD (only for touch models)

When the appliance is switched for the first time a procedure
verifies the installation and tests the appliance performances.
This procedure must be completed to guarantee the oven
performances and to allow its use.
The procedure is composed of 3 main steps:
1. General settings for interface configuration;