Table of Contents
Advertisement
Removing a extended heat sink module and extended heat sink
bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
NOTE:
The heat sink and processor are hot to touch for some time after the system has been powered down. Allow the
heat sink and processor to cool down before handling them.
Steps
1. Ensure all four Anti-Tilt wires are in the locked position (outward position), and then using a Torx T30 screwdriver, loosen
the captive nuts on the heat sink in the order that is mentioned below:
a. Loosen the first nut three turns.
b. Loosen the screw diagonally opposite to the nut you loosened first.
c. Repeat the procedure for the remaining two nuts.
d. Return to the first nut to loosen it completely.
e. Repeat the same procedure on the extended heat sink.
2. Set the Anti-Tilt wires to the unlocked position (inward position).
3. Lift the processor and extended heat sink module (PHM) from the system and set the PHM aside with the processor side
facing up.
Figure 63. Loosening the captive nuts and set the Anti-Tilt wires to the unlocked position
4. Using a Phillips 1 screwdriver, remove the screws that secures the extended heat sink bracket and lift it up from the system
board.
Safety
instructions.
Before working inside your system
.
Installing and removing system components
93
Advertisement
Table of Contents
