Heat Sink And Fan; Removing Heat Sink And Heat Sink Fan - Dell Precision 3430 Small Form Factor Service Manual
Hide thumbs
Also See for Precision 3430 Small Form Factor:
- Installation manual (6 pages) ,
- Installation manual (22 pages) ,
- Setup and specifications manual (34 pages)
Table of Contents
Advertisement
4
Install the:
a
Hard drive and optical drive module
b
Front bezel
c
Side cover
5
Follow the procedure in
Heat sink and fan
Removing heat sink and heat sink fan
1
Follow the procedure in
2
Remove the:
a
Side cover
b
Front bezel
c
Hard drive and optical drive module
3
To remove the heat sink with fan:
a
Disconnect the heat sink fan cable from the system board [1].
b Loosen the 4 captive screws that secure the heat sink [2] and lift it away from the system [3].
NOTE:
Loosen the screws in a sequential order (1,2,3,4) as mentioned on the system board.
After working inside your
computer.
Before working inside your
computer.
Removing and Installing components
41
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Precision 3430 Small Form Factor and is the answer not in the manual?