Table of Contents
Advertisement
Figure 93. Installing the OCP card filler
Next steps
1. Install the rubber tube cover. See
2.
Install the expansion card riser
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card riser
Steps
1. To remove the battery:
a. Push the battery holder clip away from the battery.
CAUTION:
To avoid damage to the battery holder clip, ensure that you do not bend the battery holder clip
while installing or removing a battery.
b. Pull the battery out of the battery holder.
install the liquid cooling cold plate with leak sensor
1.
Safety
instructions.
Before working inside your system
1.
step 6 to install the rubber tube cover.
.
Installing and removing system components
117
Advertisement
Table of Contents
