Expansion Cards And Expansion Card Risers; Removing The Expansion Card Riser 1 - Dell PowerEdge C6620 Installation And Service Manual

Figure 30. Installing the support bracket
Next steps
Follow the procedure listed in

Expansion cards and expansion card risers

NOTE: When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.

Removing the expansion card riser 1

Prerequisites
NOTE: Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
3. Remove the air shroud
4. If applicable disconnect the cables.
NOTE: The procedure to remove a riser 1a or 1b is similar.
Steps
1. Using a Phillips 1 screwdriver, remove the screws that secure the expansion card riser 1.
2. Holding the handle, lift the expansion card riser from the riser connector on the system board.
After working inside your
Safety instructions.
Before working inside your
if applicable.
system.
system.
Installing and removing system components 61