3.2. N-Sample Acquisition
Analog threshold Trigger
The analog threshold trigger starts to trigger while the input signal is higher or lower than a setting
voltage value. In addition, analog threshold trigger can be used to detect instantaneous changes in
a continuous voltage signal. The user can specify the trigger condition.
The following parameters need to be specified:
Channels (1 ~ 4)
Sampling rate (1 ~ 128 k Hz)
Target count (0 ~ 15000000)
Set analog threshold trigger condition (above high, below low, leave-region, entry-region)
Set analog threshold trigger high/low level (+10 V~ +10V)
Set trigger mode as software trigger mode
PET-AR400 User Manual
V1.0.0
Top
P.27