Table of Contents
Advertisement
Warning: Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury.
Wear Kevlar gloves or equivalent protection.
Control Panel and Front RJ45 Access
The control panel is held in place with four
Phillips-head screws and five tabs. One of the
two RJ45 connections is located behind the
control panel.
Control Panel Removal
1. Using a small flat-blade screw-driver, remove
the beauty cap from the left side of the control
panel.
2. Remove the 1/4-inch hex-head screw that
secures the access panel to the control panel.
Dryer Components
3. Then slide the access panel to the left to
reveal the RJ45 connector.
4. After the slide panel has been removed,
remove two 1/4-inch hex-head screws.
5. Pull the left side of the control panel outward
slightly to release the tabs. Then lift up
to disengage the control panel from the
mounting posts on the right side.
– 25 –
RJ45
Connector
(Continued next page)
Hide quick links:
Advertisement
Table of Contents
