Front Drum Support - Haier GE UltraFresh GFD55ESSN Technical Service Manual

5. Lift the front panel straight up to disengage
the two clips at the bottom of the panel and
the four clips from the cabinet. There are two
on each side. Disconnect the door switch
connector before pulling the front panel away
from the cabinet.
Door Switch
Connector
Front Panel
Clips
Door Switch
Connector
– 32 –

Front Drum Support

The drum support holds the front of the drum in
place utilizing two roller wheels and shaft. If the
shaft is not damaged, it can be reused.
Drum Support Removal
1. Remove the control panel, top cover and
front panel (see Control Panel and Front
RJ45 Access, Top Cover, and Front Panel
sections of this service guide).
2. Remove the four hex-head screws and one
Phillips-head post screw that secures the
control panel front bracket to the cabinet. Set
the bracket aside.
3. To remove the front drum support, the drum/
tub light will need to be disconnected at the
drum light harness connector first. The tub
light is removed from the inside of the drum.
Pinch the tabs on the back of the light and
push it to the inside of the drum.
4. Then push the arrow shaped wire tie from the
back of the support so the harness is free
from the support.