Haier GE UltraFresh GFD55ESSN Technical Service Manual page 12

A
Power
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
B
Start and Pause
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the
cycle. Pressing Start again will pause the cycle, the Start light will blink and "Pause" will
display. To continue the cycle, press Start again.
C
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle and the
dryer cycle status (Sense, Drying, Damp and Cool). In addition, the display will show:
Wi-Fi Will allow the appliance to communicate with a smartphone for remote
appliance monitoring control and notifications.
Controls The dryer is locked; will blink once if any pad is pressed or the cycle knob
is turned.
Check The Check Filter light will stay on for 15 seconds after the cycle stops.
Filter
Check The Check Vent light indicates an issue has been found due to reduced
Vent
airflow from a possible blocked or restricted vent. Checking and/or
cleaning the vent system is recommended.
– 12 –
(Continued next page)