Inlet Thermistor - Haier GE UltraFresh GFD55ESSN Technical Service Manual

2. Remove the top panel, front panel, front drum
support, blower wheel and drum (see Top
Panel, Front Panel, Front Drum Support,
Blower Wheel and Drum sections in this
guide).
3. Disconnect the harness connector from the
motor.
4. Unclip the two clamps that secure the motor
to the motor bracket.
5. Raise the back of the motor up and slide
toward the rear of the dryer.

Inlet Thermistor

The inlet thermistor is located at the back of the
dryer. It is mounted to the supply duct.
The thermistor has a negative temperature
coefficient (as temperature increases, resistance
decreases).
Resistance can be measured at the thermistor
wire harness or from the main board, two purple
wires at the J302 connector pins 3 and 4.
Thermistors Resistance Values (W)
K OHMS
76-84
95-105
118-132
– 43 –
TEMP. °F TEMP. °C
86 30
77 25
68 20
(Continued next page)