Table of Contents
Advertisement
Set output
configuration
command
2201 INSTALLATION MANUAL, Revision B
The $ message is used to configure the output of the primary
port. It contains the input/output primary port baud rate and
the list of message identifiers with their update rates.
903
Radiobeacon Proprietary Info
GGA
Global Positioning System Fix Data
GLL
Geographic Position - Latitude/Longitude
GSA
GPS DOP and Active Satellites
GSV
GPS Satellites in View
MSS
MSK Receiver Signal Status
RMC
Recommended Minimum Specific GPS Data
VTG
Track Made Good and Ground Speed
APPENDIX B
2201/NMEA
communication
protocols
Page 35
Advertisement
Table of Contents
Troubleshooting
