Table 2: Northstar 2201 (Binary) Connections - NorthStar 2201 Installation Manual

SECTION THREE Interfacing the 2201
2201-CA DATA/POWER CABLE
Pin # Wire color
(pod)
1 Blue
2 Orange
3 Green
4 Brown
5 Black
6 White
7 Red
a. This is the pin for SC104 beacon differential input.
b. If the existing installation doesn't use the honk output, connect the pink wire to black and use pin number
14 to remotely turn on the 2201 whenever the 941/951/952's power is turned on.
c. If the existing installation already uses the honk output, ground the remote-on wire (black) to always turn
on the 2201 whenever ship's power is turned on. Use the tan wire and pin number 17.
Connecting to power
Page 20

Table 2: Northstar 2201 (binary) connections

Wire
connections
(function)
RS232 RX1
(Main receive
port)
RS232 RX2
(Aux receive
port)
RS232 TX1
(Main transmit
port)
Signal gnd
Remote
power- on
Ship's power
control
Power gnd Connect to
ship's ground
(system gnd)
Power in Connect to
ship's power
(9-36 VDC)
To connect the 2201 to power:
1. Splice or terminate the 2201-CA's cable ends to power.
There are two possible wiring options for power-on:
•
•
Function
<-----------> RS232 TX
Connect
Not
a
connected
<----------> RS232 RX
Connect
<----------> Ground
Connect
b
<----------> Honk
Connect
c
<----------> Ground
Connect
using the 941/951/952's remote power-on feature
using the ship's power control
2201 INSTALLATION MANUAL, Revision B
WA215 I/O CABLE
Wire color Pin #
(941, 951,
or 952)
Red 18
Green 16
Tan 17
Pink 14
Tan 17