Figure 3: 2201 Mounting Configuration For A Flat Surface (As Shown From Underneath) - NorthStar 2201 Installation Manual

SECTION TWO Installing the 2201
Mounting on a flat surface
1.00-14UNS-2B X 1.00
Page 16
You can mount the 2201 on a deck or any other flat surface.
Using the three screws and washers provided, mount the 2201
on the flat surface with three holes on a 1.75-inch diameter
circle (see Figure 3 below). Ensure that the 2201 has enough
mounting clearance to easily connect the cable. For example,
mount it at the edge of the deck, or drill a small hole in the
deck or other surface to allow the cable to pass through.
deep
Figure 3: 2201 mounting configuration for a flat surface
3X .190-32UNF-2B X .48 deep.
Mounting holes equally spaced around a
1.75-inch diameter circle.
Connector receptacle with 7 male contacts.
Switchcraft EN3P7MP or equivalent
Mating: EN3C7FC or equivalent
(as shown from underneath)
2201 INSTALLATION MANUAL, Revision B