Bomag BPR 30/38-3 Operating Instructions And Maintenance Instructions page 37

M a i n t e n a n c e e v e r y 6 m o n t h s
Maintenance every 6 months
4.10 Checking the oil level in the
vibrator housing
i
Note
Park the machine on level ground.
Fig. 40
Unscrew filler and level plug (Fig. 40).
l
The oil level must reach the bottom edge of the
l
filler and level bore, if necessary fill in oil.
For quality of oil refer to the table of fuels and
lubricants.
Turn the filler and level plug back in with a new
l
seal ring.
3 6
4.11 Cleaning cooling fins and
cooling air openings
Fig. 41
Brush off dried on dirt from all cooling fins and
l
cooling air openings and blow the dirt off with
compressed air (Fig. 41).
Clean an oily dirt with a cold cleansing agent.
l
After a sufficient soaking time clean off with a
l
water or steam jet and blow out with com-
pressed air.
Run the engine warm for a while to avoid cor-
l
rosion.
Caution
!
Do not guide the water jet directly into air filter/
carburettor, starter/air intake and oil warning
light/ignition switch.
B O M A G
BPR 30/38-3 / BPR 35/38-3