Symbols On The Product - Ryobi R80XZTR30 Manual

6. Seat (with operator presence safety interlock
system)
The seat has an interlock system that stops the blades if
the operator leaves while the mower is running.
Test the system before each use to ensure that it is
working correctly.
1. Stop the product on a level surface, and engage the
parking brake.
2. Set the joystick in the neutral position.
3. Insert the start key, and turn the key to the ON position.
4. Pull up the blade engage knob to activate the blades.
5. Briefly stand up but do not get off the mower.
The blades should stop within 5 seconds. If the blades
do not stop, contact an authorised service centre. Do not
operate the mower until the safety interlock system has
been repaired.
7. Intelligent Drive System joystick
The Intelligent Drive System joystick automatically
returns to the neutral position for safety. The joystick
easily allows the user to operate the product with only
one hand. The software is designed to correct gradual
wheel turns to help eliminate divots in the lawn.
8. Storage bucket
9. Seat adjustment lever
10. Deck height adjustment lever
The deck height adjustment lever raises or lowers the
cutting deck.
11. Rear tyre
The rear tyres are powered by independent motors to
prevent any rear end movement while travelling over low
traction surfaces.
12. Headlights
The front LED headlights can be controlled from the LCD
interface.
13. Parking brake
The parking brake locks the product in the brake position.
14. Front tyre
The front tyres rotate 360 degrees for manoeuvrability.
15. Brake pedal
The brake pedal slows down and stops the product.
16. Side discharge chute
17. Mulch cover
The mulch cover covers the side discharge chute,
which allows the mower blade to cut and recut for finer
clippings.
18. LCD screen
The LCD screen monitors and activates the features on
the product. Refer to the LCD user guide.
19. Seat pivot bushing
20. Seat hinge bracket
21. Armrest knob
The armrest knob secures the armrest into place.
22. Primary 80 V battery port
The battery bucket can store up to three 80 V battery
packs.
23. Quick-connect plug
24. Battery latch
25. Charger (80 V)
The charger recharges the batteries of the mower.
26. Hitch plate
27. Battery pack (80 V)
80 V battery packs must be used to power the product.
28. Operator's manual
The operator's manual provides important safety
warnings and instructions on how to properly and safely
operate and maintain the product.
29. Start key
The start key turns the power switch to the on, off, or
accessory position.
30. Battery pack (36 V)

SYMBOLS ON THE PRODUCT

Safety alert
Read and understand all instructions
before operating the product. Follow
all warnings and safety instructions.
Wear eye protection.
Beware of thrown or flying objects.
Keep all bystanders, especially
children and pets, at least 30.5 m
away from the operating area.
Never carry children or anyone, even
when the blades are off.
Always look down and behind you
before and during backing and make
sure children, bystanders, and pets
are clear of the area.
Do not operate the product on inclines
greater than 12°. Mow up and down
slopes, not across.
12
Stay at least two moving widths (2.14
m) away from any ditches, drop-offs,
or water. Front caster wheels can
m
rotate when the mower is stopped,
even with the brake applied, and can
cause mower to go over the edge or
into the water.
Keep hands and feet away from
rotating blades.
Do not expose the battery, battery
compartment, or electronic
components to rain, water, or liquids.
Do not charge the battery or
expose the product to rain or damp
conditions.
Keep hands and feet away from the
blade and cutting area.
99
Guaranteed sound power level
7
Original Instructions