Table of Contents
Advertisement
movement or falling to prevent injury to persons or
damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only.
■
You may make adjustments and repairs described in this
manual. For other repairs, have the product serviced by
an authorised service centre only.
■
Turn off the product, and remove the safety key and the
battery pack. Make sure that all moving parts have come
to a complete stop before any cleaning or maintenance
task.
■
Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure that the product is in safe
working condition.
■
After each use, clean the plastic parts with a soft, dry
cloth. Any part that is damaged should be properly
repaired or replaced by an authorised service centre.
■
Replace damaged blades and bolts in sets to preserve
balance.
■
Be careful during adjustment of the product to prevent
entrapment of the fingers between moving blades and
fixed parts of the product.
■
The blade on the product is sharp. Use extreme caution,
and wear heavy-duty gloves when fitting, replacing,
cleaning, or checking bolt security.
■
The blade bolts must be adequately tightened. See the
manufacturer's recommendations for blade bolt torque,
which can be found in the product specification table in
this manual.
■
Be aware that even though the power source is turned
off, the blades can still be moved.
CLEARING BLOCKAGES
■
Turn off the product, and remove the safety key and the
battery pack. Make sure that all moving parts have come
to a complete stop.
■
Always wear heavy-duty gloves when checking or
clearing a blockage. The blades are sharp, and the
blockage itself could be a sharp object.
■
Remove the grass catcher. Check and carefully clear the
grass catcher for obstructions.
■
Check the grass discharge chute, and carefully clear
blockages.
■
Turn the product on its side. Check its underside and the
area around the blade. Carefully remove any blockages.
Remember that the blade may move during cleaning.
SYMBOLS ON THE PRODUCT
Safety alert
Read and understand all instructions
before operating the product. Follow all
warnings and safety instructions.
Beware of thrown or flying objects.
Keep all bystanders, especially
children and pets, at least 15 m away
from the operating area.
Keep hands and feet away from
the blades. Remove the battery pack
before maintenance.
Wear eye protection.
Wear ear protection.
Do not operate the product on inclines
greater than 15°. Mow across the face
of slopes, never up and down.
Do not expose the product to rain or
damp conditions.
96
Guaranteed sound power level
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
Press the start button, then squeeze
and hold either side of the on/off lever
to turn on the product.
5
Original Instructions
Advertisement
Table of Contents
