Table of Contents
Advertisement
9. If front-to-back adjustment is needed,
turn the adjustment nuts clockwise to
raise or counterclockwise to lower the
back of the cutting deck. Each full turn
of the adjustment nut changes the deck
height approximately 0.32 cm (1/8 in.).
Measure the distance between the blade
and ground again to verify that the front
tip is now 3.1 mm to 9 mm (1/8 in. to 3/8
in.) lower than the rear tip. If not, continue
to adjust and measure until the distance
is correct.
NOTE: Make sure to turn the adjustment
nuts on both sides equally to prevent
throwing the side-to-side measurement
off again.
10. Without moving the adjustment nuts,
retighten the jam nuts to secure the
adjustment nuts in place.
11. Lift the side discharge chute. Install the
mulch cover. Hook the latch to the stud
on the housing.
9
10
11
3.2 - 9 mm
31
Maintenance
Advertisement
Table of Contents
