Routed; Displaying Routing Information - Bay Networks 5390 Administering

Communications server

Hide thumbs Also See for 5390:

Table of Contents

Internet Protocol (IP) Routing

The following na command speciﬁes that RIP does not advertise subnet routes over the Model 5390

Ethernet interface. Note that the Model 5390 server must be rebooted to effect the change to en0.

admin: set interface=en0 rip_sub_advertise n

You may need to reset the appropriate port, Annex

subsystem or reboot the Annex for changes to take effect.

annex#: boot

routed

The Model 5390 routed parameter enables and disables RIP. The syntax is:

routed {Y | N}

Y enables RIP, N disables it. Setting routed to Y activates both passive and active RIP if the

option_key parameter is set for active RIP; otherwise, only passive routing is enabled. The default

Reboot the Model 5390 server to put this parameter setting into effect.

This section describes three diagnostic tools that let you:

Display RIP interface statistics.

Display the contents of the Model 5390 routing table.

Trace the path of a packet as it is routed to its destination.