Clearing And Acknowledging - ABB RELION REX640 Operation Manual

Using Web HMI
2.
5.14

Clearing and acknowledging

Reset, acknowledge or clear all messages and indications, including LEDs and
latched outputs as well as registers and recordings, in the Clear page.
1.
2.
76
Click Store Changes to store the values to the flash memory.
Click Reject Changes to cancel saving settings. If the parameter
has an edit-copy, the original parameter value is restored. If the
parameter does not have an edit-copy, the edited parameter value
remains visible until the protection relay is rebooted. However, the
edited value is not stored in the nonvolatile memory and thus the
reboot restores the original value.
Figure 67: Storing changes
Storing values takes a few seconds.
If the values are not stored, they are not taken into use and they are
lost after a reboot.
Select Device on the menu bar.
Select Clear from the drop-down list.
Figure 68: Opening the Clear page
1MRS759118 D
REX640
Operation Manual