Section 5
Using the HMI
1.
Press
2.
Press
3.
To save the changes in non-volatile memory, select Yes and press
A071206 V2 EN-US
Figure 30: Confirming settings
•
•
5.1.14
Clearing and acknowledging
The Clear button is used to reset, acknowledge or clear all messages and indications, including
LEDs and latched outputs as well as registers and recordings. Press the Clear button to activate a
selection menu, and select the wanted clearance or reset function. Events and alarms assigned to
alarm LEDs are cleared with the Clear button as well.
1.
Press
60
to confirm any changes.
to move upwards in the menu tree or
To exit without saving changes, select No and press
To cancel saving settings, select Cancel and press
Pressing Cancel in the Save changes dialog closes only the Save changes dialog
box, but the IED remains in editing mode. All the changes applied to any setting are
not lost and the user can continue to change settings. To leave the change setting
mode, select No or Yes in the Save changes dialog.
After changing the parameters marked with !, the IED restarts automatically for the
changes to take effect.
to activate the Clear view.
© Copyright 2011 ABB. All rights reserved
to enter the Main Menu.
.
.
.
1MRK 500 093-UUS A
AMU0600425 v7
650 series
Operation manual