ABB RELION REX640 Operation Manual page 56

Using HMI
56
Figure 37: Confirming object closing
Control operations cannot be executed from the SHMI navigation
page. Navigate to the HMI view to perform control operations.
Close delay mode in Configuration > Control > LHMI is set
If the parameter
to "In use", a timer is started after tapping the close button and accepting
the possible confirmation dialog. Close operation is performed only after the
timer reaches zero. Remaining time is displayed on top of close button, user can
cancel the operation during countdown by tapping the Cancel button. The delay
time can be configured by setting
Control > LHMI.
Close delay parameter in Configuration >
1MRS759118 D
REX640
Operation Manual