Installation - Cattani ISO 18 Manual

Replacement of the amalgam collection container
• Electrical shock risk : also 230 V
• General danger sign.
• Biological danger, risk of infections from epidemic diseases.
• Compulsory direction of fl ow or of rotation.
Before intervening, wear disposable gloves, mask and goggles to protect from pos-
sible splashes. Disconnect from the mains the machine on which the Hydrocyclone is
mounted, open the screw tap (25) and the drain tap (26). Wait until the liquids contained
in the Hydrocyclone and part of those inside the collection container have drained back
into the centrifugal separator.
Support the amalgam container while slowly lifting the securing handle (27), then remove
the container and fi ll it with a suitable disinfectant (refer to the importer for suggestions
regarding the most suitable product). Open the valve (28) placed on the cover (29) of
the container (5), treat the "O" ring of the valve with a thin layer of Lubri-Jet, position
the cover on the container and close the valve (28).
The container is made of unbreakable material and is fi tted with a hermetically sealed
lid, since the contained material is toxic and contaminating for epidemic diseases (we
recommend to handle it with care).
To receive a list of authorized companies with licence for transport and disposal of
this kind of waste and for further information regarding the disposal, contact trading
associations or local competent authorities.
Position a new container in the seat of the original one, then lower the handle to make
it adhere to the container. To start the machine again, close the screw tap (25) and the
drain tap (26).

Installation

(draw. 2 page 42)
• Electrical shock risk : also 230 V
• General danger sign.
• Biological danger, risk of infections from epidemic diseases.
• Compulsory direction of fl ow or of rotation.
Install the Hydrocyclone below the separator in the vertical position as follows:
1) Fix the L-shaped bracket (9) on the base by placing the bracket on the holes and
fastening.
2) Mount the bracket (11) without disassembling the Hydrocyclone, as shown in the
drawing.
The Hydrocyclone must be easily accessible from every side. Leave a free space of at
least 3 cm under the amalgam container (5) so it can be easily removed.
The fi lter (17) fi tted to the centrifugal separator has a particle size not larger than 1.2 mm,
protecting the Hydrocyclone from larger particles which may damage it.
(draw. 7 page 47)
can be lethal.
can be lethal.
16